Seymour Duncan #11900-011 Killing Floor High Gain Boost / Overdrive Pedal

SEYMOUR DUNCAN "KILLING FLOOR" HIGH GAIN BOOST

SOUNDS WICKED? WELL, IT IS!!!

The Killing Floor High Gain Boost is both a volume boost and a musical amp-like overdrive all in one. The Killing Floor High Gain Boost gives you both a volume boost and a musical amp-like overdrive all in one, with an unmistakable, undeniable bluesy feel. Use it to boost your overall output for solos, to push an amp further into overdrive, or for a beefy, expressive solo tone. It’s also great as an ‘always on’ pedal for adding the finishing touch to your tone; it’s like an overall enhancer for your entire sound.

The single control knob gives you up to a whopping 34 dB of additional gain for amazing range, from subtle boost to brash chords to a full, fat overdriven lead, while the 3-way Voicing toggle switch lets you sculpt your high end with a boost at 10K, a cut at 4.8K or a flat setting. Use this switch to take the bite out of overly bright single coils, put more sting into a dark humbucker or to add crystal clear, boutique-style airiness to your tone.

The Killing Floor is made in the USA and is True Bypass.

SPECIFICATIONS:

Type of circuitry : The Killing Floor uses a hybrid J-FET/Op-Amp, optimized for low order harmonics

Bypass : True hard-wire bypass

Control Functionality:

- Gain Control Range : 0dB to 34dB

Voicing Switch:

- Up : High Boost, 7 dB @ 10 kHz

- Middle : Flat Response

- Down : High Cut, 1st order, -3dB @4.8 kHz

Bypass (Footswitch) : Engages the boost effect

Input Impedance : 1M Ohm

Output Impedance : 1K Ohms

Gain : Unity (0dB) dry ; off to +3dB wet

THD @ 1 Vo: Unity (0dB) dry ; off to +3dB wet.

Noise referred to input : 120dBV (with Gain set for 34dB)

Power : 9V battery or external 9V to 18V Regulated DC Adapter (center negative)

Current Consumption : 3.7mA in active mode, 2.2mA in bypass mode

Dimensions : 2.61” X 4.90” X 1.40”

Weight : 0.8lbs without battery, 0.9lb. with battery